行業資訊

彩色瀝青冷補料的養護要注意什么？

來源：http://m.9real.cn/ 日期：2022-03-17

春季：要防止路面構造發作而形成凍脹，在路面表層有水痕的部位，需求在路肩路基邊坡處挖排水滲溝，將冬季蓄積的雨水排到構造之外。也可在彩色瀝青路面上覆撒干土，干土一方面能夠吸收路面構造中的水分，另一方面還可減緩熱量沿路面構造下傳的速度，使路面構造中的凍水遲緩消融，并自行逐漸浸透到排水溝中，防止路面構造發作溶融性破懷。

Spring: to prevent frost heaving caused by the occurrence of pavement structure, where there are water marks on the surface of the pavement, it is necessary to dig a drainage seepage ditch at the shoulder subgrade slope to drain the rainwater accumulated in winter out of the structure. The colored asphalt pavement can also be covered with dry soil. On the one hand, the dry soil can absorb the water in the pavement structure, on the other hand, it can also slow down the transmission speed of heat along the pavement structure, slow the melting of frozen water in the pavement structure, and gradually soak into the drainage ditch by itself, so as to prevent the dissolution of pavement structure.

夏季：氣溫高，彩色瀝青路面就十分容易老化，使路面成波浪狀。這種狀況下，可采取灑水降溫措施。灑水普通在下午兩點左右中止，水量不能太大，以濕潤潮濕為宜，可多灑兩遍，但不能構成路面積水及影響交通平安。

Summer: when the temperature is high, the colored asphalt pavement is very easy to age, making the pavement wavy. In this case, watering and cooling measures can be taken. Watering is usually stopped at about 2 p.m. the amount of water should not be too large. It is appropriate to be wet and wet. It can be sprinkled twice more, but it can not form Road area water and affect traffic safety.
濟南瀝青料

秋季：要做好公路沿線邊溝積水的引導排放工作，防止這些積水成為冬季路面構造凍結毛細水的補給水源。夏季要做好路面排水，防止彩色瀝青路面構造處于濕潤工作狀態而惹起毀壞。

Autumn: it is necessary to guide and discharge the accumulated water in the side ditch along the highway to prevent these accumulated water from becoming the supply source of frozen capillary water in the pavement structure in winter. Pavement drainage shall be done well in summer to prevent damage caused by wet working condition of colored asphalt pavement structure.

冬季：要將縱橫裂痕處打掃潔凈，用液化氣將縫壁加熱至粘性狀態后，再把瀝青或瀝青砂漿(在低溫濕潤時節宜噴灑乳化瀝青)，噴抹到縫中，再勻撒一層2～5mm的枯燥干凈石屑或粗砂加以維護，后用輕型壓路機將礦料碾壓。假如是細小的裂痕，則要預先用盤式銑刀停止擴寬，再按上述辦法做處置，沿裂痕涂刷少量稠度較低的瀝青。

Winter: clean the vertical and horizontal cracks, heat the joint wall with liquefied gas to the viscous state, then spray asphalt or asphalt mortar (emulsified asphalt should be sprayed in the low-temperature wet season) into the joint, and then evenly sprinkle a layer of 2 ~ 5mm dry and clean stone chips or coarse sand for maintenance, and then roll the mineral aggregate with a light roller. If it is a small crack, stop widening with a disc milling cutter in advance, and then handle it according to the above method, and brush a small amount of asphalt with low consistency along the crack.

上一條：公路施工材料

下一條：六個壓路機必看的知識點